To stay within UL guidelines, Power House increased power cord gauges in May 2017.
Please refer to the Ordering Guide for assistance.
16/3 – Ice Eater with 25′, 50′, or 100′
14/3 – Ice Eater with 150′ or 200′
& all Surface Aerators & Aerating Fountains made before May 8, 2017
12/3 – all Surface Aerators & Aerating Fountains made after May 8, 2017
SJTOW UL & CSA Approved – Underwater Rated Cable
Potted Quick Disconnect
Unplug the unit from the power source.
Loosen and remove existing power cord.
Take new power cord and run through the 2 1/2″ hole
Line up the pins and holes from the power cord and connector on the end bell, then twist it on.
Make Sure to Hand Tighten Only – Do Not Over Tighten – Do Not Use Tools
In order to prevent the power cord from hitting the propeller, pull out additional slack through the 2 1/2″ hole and secure with clip and screw. One additional measure you can take is to secure the power cord to a bracket with a zip tie and then secure with the clip and screw on the shroud.
Spin the propeller by hand after you complete the install to make sure the propeller does not hit the cord.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov